Thanks Thanks:  0
Likes Likes:  4
Results 1 to 4 of 4
  1. #1

    Default Handle for Loop Cross S1

    Hi
    I have recently aqquired a set of Loop Cross s1 rod blanks with the intention of building it to the same specification as a factory built rod,
    I have managed to obtain the butt section of the same rod 12' #7 4 piece which has been damaged , but the handle and reel fitting are undamaged. Is there a way in which i can remove the corks and reel fitting intact , so that i can fit them on the new blank handle ?.
    Regard's
    DURHAMSTICKMAN

  2. #2
    Join Date
    Feb 2012
    Location
    Belgium
    Posts
    550

    Default

    Gradually melt the glue with a heat gun (no flame!). It will be more difficult with the cork than with the reel holder. Good luck.
    firefly

  3. #3
    Join Date
    May 2011
    Location
    Kingskerswell, Newton Abbot. Devon
    Posts
    1,243

    Default

    You’re never going to remove the corks and put them on the new rod, also you’ll be very lucky if you you can do the same with the screw winch, depends what glue they use.
    You’re better off upgrading the screwwinch with a better one making it down locking and make the handle yourself, take measurements to get a similar finished size. There are plenty of videos of how to do it or get a professional to do the handle. I have built a few rods in the past and I wouldn’t use anything but new fittings on that rod

  4. #4

    Default

    As above, I wouldn't entertain the idea of salvaging anything off the blank. Get yourself some decent Flor grade cork, a quality reel seat and let your imagination run. You'll end up with something far more striking and personal to you than a boring factory rod!

    A warning though, its pretty addictive and once you've built one it wont be the last.........

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •